For a 2015
NOTE: If initializing both roof opening panel motors, initialize the front sliding glass motor before initializing the shield (sunshade). A new front sliding glass panel motor will only move to the vent position and must be initialized
Front Sliding Glass Panel
1. NOTE: The driver front door must be open during the entire procedure.
Open the driver front door.
2. Turn the ignition to the ON position.
3. NOTE: Complete the following within 5 seconds:
A. Cycle the ignition to the OFF position and then back to the ON position.
B. Press the sliding glass panel close switch for less than one second and release.
C. NOTE: When the sliding glass panel close switch is pressed and held, there should be an audible click from the switch within 3 seconds. The audible click indicates that the
motor has accepted the request to initialize. If there is no audible click, the procedure must be repeated from step 1.
Press and hold the sliding glass panel close switch until the glass moves to the fully open and the back to the fully closed position (this could take up to 20 seconds to start).
4. Release the switch and verify successful initialization by carrying out one-touch open, one-touch close and one-touch vent operations.
Shield (Sunshade) Initialization
1. NOTE: The driver front door must be open during the entire procedure.
Open the driver front door.
2. Turn the ignition to the ON position.
3. Press and hold the shield (sunshade) control close switch until the shield is in the fully closed position.
4. NOTE: Complete the following within 5 seconds:
A. Cycle the ignition to the OFF position and then back to the ON position.
B. Press the shield (sunshade) control close switch for less than one second and release.
C. NOTE: When the shield CLOSE switch is pressed and held, there should be an audible click from the switch within 3 seconds. The audible click indicates that the motor has
accepted the request to initialize. If there is no audible click, the procedure must be repeated from step 1.
Press and hold the shield (sunshade) control close switch until the shield moves to the fully open position and then back to the fully closed position (this can take up to 20
seconds to start).
5. Release the switch and verify successful initialization by carrying out one-touch open operation.
